4.9 from 179 Google reviews(03) 9434 7677

Caring for hybrid and laminate floors

Sweep, damp mop with a neutral cleaner, and keep steam mops away. A simple care routine that keeps hybrid and laminate looking right.

Care and installation5 minute readDiamond Valley Carpets, Greensborough

Caring for hybrid and laminate floors is simple. Remove grit with a vacuum or soft broom, clean with a damp (not wet) mop and a pH neutral cleaner, and wipe up spills promptly. Avoid steam mops, wax, polish and harsh chemicals. Felt pads under furniture and mats at outside doors prevent most scratches.

The details below will help the floor last and keep you on the right side of the warranty.

Everyday cleaning

Get the grit off first. Small bits of sand and dirt act like sandpaper under shoes and chair legs. Vacuum with the hard floor setting (brush roll off) or use a soft broom or microfibre dust mop. In busy homes, a few times a week is about right.

Damp mop, not wet mop. Wring the mop out until it is only just damp. A light, even pass is all the floor needs. Puddles of water sitting on the floor are the thing to avoid, especially on laminate.

Use a neutral cleaner. A pH neutral floor cleaner, mixed as the label says, is safe for both. Many makers sell their own. Avoid:

  • bleach and ammonia
  • vinegar in strong mixes
  • oil soaps, waxes and polishes
  • abrasive powders and scouring pads

Polishes and waxes do not soak in. They sit on top, build up, and leave a dull or sticky film that shows footprints.

Steam mops

This is the one people ask about most. Steam pushes heat and moisture down into the joins between boards. Laminate cores are made from wood fibre, and steam can cause the edges to swell. Hybrid cores are waterproof, but the heat can affect the click joints and the surface layer.

Most hybrid and laminate warranties exclude damage caused by steam cleaning. A damp microfibre mop does the job just as well.

Spills and accidents

Wipe up spills as soon as you see them.

  • Laminate: the surface is sealed, but water left sitting on the joins can get into the core. Once the edges swell, they do not go back.
  • Hybrid: the boards will not swell, but water can still run between the boards to the floor underneath. Dry it up rather than leaving it.

For sticky spots, a little of your neutral cleaner on a cloth works. For marks like crayon or shoe scuffs, a soft cloth usually lifts them. Test anything stronger in a hidden spot first.

There is more on why the two floors behave differently with water in hybrid or laminate.

Preventing scratches and dents

  • Felt pads under chair legs, table legs and the feet of couches. Check them every few months, as grit gets stuck in them and they wear thin.
  • Lift, don't drag. Moving a fridge or couch across the floor is the most common cause of deep scratches.
  • Mats at outside doors. A good mat outside and another inside catches most of the grit before it reaches the floor.
  • Watch the backing on rugs and mats. Some rubber or latex backed mats can stain vinyl surfaces, including hybrid. Choose mats the maker says are safe for vinyl floors.
  • Office chairs. Chair castors grind grit into the surface. Use a chair mat, or swap to soft castors made for hard floors.
  • Pets. Keep claws trimmed. Large dogs running and turning on a hard floor will leave marks over time on any surface.
  • Heavy furniture. Wide, flat pads under heavy items spread the load and reduce dents.

Sun, heat and the expansion gap

Hybrid and laminate are floating floors. They sit on the sub-floor without being fixed down, and they expand and shrink slightly with temperature and humidity. The installer leaves a small gap around the edges, hidden by skirting or scotia, for this movement.

To keep it working:

  • Do not fix heavy items through the floor. Kitchen islands, built-in cabinets and heavy units should not be screwed down through a floating floor. It pins the boards and stops them moving.
  • Keep the edges clear. Do not fill the gap with silicone or wedge things into it, except where the maker specifies sealing in wet areas.
  • Shade hot rooms. Melbourne summers bring strong afternoon sun into north and west facing rooms. Blinds or curtains during the hottest part of the day reduce fading and limit heat movement in the boards. Sun-resistant hybrids like Sun-Plank handle this better, but shade still helps.

Small repairs

Keep a few spare boards from the job in the garage or a cupboard. If a board is badly damaged, a flooring installer can often replace it. Boards from a later batch may not match exactly, so spares from the original job are worth keeping.

Small chips can be filled with a colour matched repair kit from the maker.

Keep the warranty paperwork

Keep your invoice and the care guide that came with the floor. If you ever make a warranty claim, you will be asked how the floor has been cleaned and looked after.

Ask us about a mark or a damaged board

If you have bought hybrid or laminate from us and want advice on a cleaner, a mark that will not shift or a board that needs replacing, call (03) 9434 7677 or call in to the showroom at 19 Sherbourne Road, Greensborough. You can also browse our hybrid flooring and laminate flooring ranges.

Common questions

Can I use a steam mop on hybrid or laminate flooring?
It is best not to. Steam can force moisture and heat into the joins, which can damage laminate cores and the locking edges of hybrid, and many warranties exclude steam damage.
What is the best way to clean laminate floors?
Vacuum or sweep to remove grit, then use a well wrung damp mop with a pH neutral floor cleaner. Avoid soaking the floor and wipe up spills straight away.
How do I stop scratches on a hybrid floor?
Put felt pads under furniture, use mats at outside doors to catch grit, keep pets' nails trimmed, and lift furniture rather than dragging it.

Tell us about the rooms and we'll email you pricing.

Leave a few details, or email your floor plans to enquiry@diamondvalleycarpets.com.au, and we'll send pricing options across different grades to suit your budget. Or ring us now and talk it through.

  1. We email your pricing. We send pricing options across different grades, based on your floor plans or measurements.
  2. You choose. Visit the showroom to see the colours in person, and borrow our large samples to try at home.
  3. Final measure and install. Steve visits to take the final measurements, then our own team installs your new floor.

Call (03) 9434 7677 Email us

Please tell us your name.

We email your pricing options, so we need an email address.

Please add a phone number in case we have a question.

Which suburb is the job in?

What are you after? Pick any

We'll email you pricing options. Have a floor plan? Email it to enquiry@diamondvalleycarpets.com.au. Prefer to talk now? (03) 9434 7677